Motor building stand

eyedragaknee · Post by **eyedragaknee** » Sat Jan 17, 2009 10:53 pm

FYI if interested. Mounts to botton engine mount on oil pump and back 2 engine mt holes. Works great so far.

1" square tubing with (4) 1/4" x 1" uprights.

Beats the crap out of rolling it around on a bench.

Gunner_CAF · Post by **Gunner_CAF** » Sat Jan 17, 2009 11:02 pm

Nice stand!!

Gunner

byrdman76 · Post by **byrdman76** » Tue Jan 20, 2009 9:57 am

Very nice JR - allot better than stacked 2x4's!

Goodysnap · Post by **Goodysnap** » Tue Jan 20, 2009 6:40 pm

Mount that baby to a boat seat swivel on the work bench and that would be sweet. I've found the need to rotate the assembly alot and that would work awesome.

eyedragaknee · Post by **eyedragaknee** » Wed Jan 21, 2009 1:23 pm

That plate is the top of one of my roll around bike build stands, I just spin the whole mess around. Once you get the trans and crank in and bolt the halves together, it works fine for everything else.

rbaselt · Post by **rbaselt** » Sun Feb 01, 2009 8:52 am

Nice work! What process did you use to clean your crankcase halves? --Randall

eyedragaknee · Post by **eyedragaknee** » Sun Feb 01, 2009 1:26 pm

http://www.2wheelconnection.com/current_projects.html

Pic says it all

...also a SWEET new cyl head from LM:)

Honda305.com Forum

Motor building stand

Motor building stand

Engine stand

swivel

crank cases