1966 CB77 Restoration Project

Merz64cb77 · Post by **Merz64cb77** » Tue Feb 06, 2018 6:49 pm

That’s the largest collection I’ve ever seen!!

Seadog · Post by **Seadog** » Tue Feb 06, 2018 7:25 pm

I've sent you a PM, G.

G-Man wrote:How about I send you one of these in exchange for the kickstart cover you sent me? It will have a new needle roller, and zinc plated spring, plunger & bolt'

Just let me know whether it's narrow or wide and what the wheel diameter might be...

G

G-Man · Post by **G-Man** » Wed Feb 07, 2018 2:23 am

If you could find a good Kawasaki cam guide wheel - we could do you one of these........

The supply seems to have dried up a little.

G

Seadog wrote:I've sent you a PM, G.

G-Man wrote:How about I send you one of these in exchange for the kickstart cover you sent me? It will have a new needle roller, and zinc plated spring, plunger & bolt'

Just let me know whether it's narrow or wide and what the wheel diameter might be...

G

Seadog · Post by **Seadog** » Wed Feb 07, 2018 6:31 am

There’s a thought. Thanks, G. I’ll see what I can find.

G-Man wrote:If you could find a good Kawasaki cam guide wheel - we could do you one of these........

The supply seems to have dried up a little.

G

Seadog · Post by **Seadog** » Fri Feb 09, 2018 5:06 pm

I took a break from spending money on parts today to clean out the lower crankcase, which was pretty filthy. In the muck, I found a sheared off gear dog, which made me give the transmisson shafts a closer look. I already knew that 1st on the secondary shaft was bad, but only because the kick start teeth were worn. Sure enough, I found that 1st & 3rd on the primary and 3rd on the secondary shafts were missing half of their dogs. Where the other broken dogs disappeared to, I do not know, but now 4 new gears are needed. A bit disappointing, but certainly not the end of the world. It really wouldn't be half so fun if everything was easy.

[/url]

Geoff Hastings · Post by **Geoff Hastings** » Fri Feb 09, 2018 5:39 pm

I like the engine stand John, I was too lazy and just used two blocks of wood. If I have to pull the engine apart again I'll make a stand similar to yours.

rrekr · Post by **rrekr** » Sat Feb 10, 2018 9:58 am

Hi Seadog
The sliding gears had six engaging dogs while the fixed gears had three. Is that what you are seeing?