CL77 ignition switch compatibility

180degree · Post by **180degree** » Fri Oct 13, 2017 8:19 am

I had a question regarding the ignition switch for a CL77. Would it be possible to make a switch from a CB77 work on a scrambler? As far as I can see they look about the same but didn't know if there was something I'm missing.

OldScrambler · Post by **OldScrambler** » Fri Oct 20, 2017 8:53 pm

The outer dimension and retainer ring size and smaller on the CB units. It could be made to fit...........but I would sell what you have and get the correct unit....similar value and what you have does not match the fork lock.

180degree · Post by **180degree** » Fri Oct 20, 2017 11:22 pm

Thanks for the information, I took my CL77 ignition switch out yesterday and compared them and I see what you are describing. I think I'll go with your advice and try to look for the correct ignition switch. I took some pictures of the switch and fork lock that I have and I'll post it here in case anyone is interested in it.

OldScrambler wrote:The outer dimension and retainer ring size and smaller on the CB units. It could be made to fit...........but I would sell what you have and get the correct unit....similar value and what you have does not match the fork lock.