305 dream engine problems

64dreamman · Post by **64dreamman** » Wed May 28, 2014 2:55 pm

well im ina bit of a problem, ive rebuilt my engine. new rings gaskets etc I put the cylinder on and it went flawlessly put the head on again flawlessly so I wanted to see if I had good compression, good compression on one side and NONE on the strator side, come to find out the valves aren't seating and I leak tested it and so now heres my question how do I manage to get the 4 screws out of the cam cover withought them stripping?

Hahnda · Post by **Hahnda** » Wed May 28, 2014 9:31 pm

Do you have an impact driver? You need the kind you whack with a hammer.

SWARDLAW · Post by **SWARDLAW** » Thu May 29, 2014 10:59 am

Is the problem with the valves leaking just a tight valve lash setting?

LOUD MOUSE · Post by **LOUD MOUSE** » Thu May 29, 2014 2:45 pm

How did you adjust the valves?. .........lm

64dreamman wrote:well im ina bit of a problem, ive rebuilt my engine. new rings gaskets etc I put the cylinder on and it went flawlessly put the head on again flawlessly so I wanted to see if I had good compression, good compression on one side and NONE on the strator side, come to find out the valves aren't seating and I leak tested it and so now heres my question how do I manage to get the 4 screws out of the cam cover withought them stripping?

Honda305.com Forum

305 dream engine problems

305 dream engine problems

Re: 305 dream engine problems