CB160 piston rings?

kalchcliff · Post by **kalchcliff** » Fri Aug 26, 2011 1:46 pm

Hello all. I have a set of rings for my CB160. Part # 13020-028-020, .25 over. This set has six rings that look real close to fitting but everything I have found out about them shows for a Honda 90 single cylinder. Any info out there?

davomoto · Post by **davomoto** » Fri Aug 26, 2011 3:32 pm

The center code 028 is for an S90. I don't know if they are the correct diameter or thickness for your bike. There must be a forum for the 160s, as they are quite popular as vintage race bikes.

Davo

G-Man · Post by **G-Man** » Fri Aug 26, 2011 4:29 pm

Hi

S90 and CB160 are the same bore at 50mm. Model code for CB160 is 217. If the rings fit the piston and the bore then you should be fine.

G

kalchcliff · Post by **kalchcliff** » Tue Aug 30, 2011 11:21 am

Thanks guys. Will proceed.

roadcapDen · Post by **roadcapDen** » Fri Nov 11, 2011 10:37 am

The only forum I could find for CB160's was CA racers, not much there?

brewsky · Post by **brewsky** » Fri Nov 11, 2011 11:58 am

Maybe here?
http://www.hondatwins.net/forum/index.php

kalchcliff · Post by **kalchcliff** » Fri Nov 11, 2011 1:52 pm

Try F-160. CB160 racers mostly on the west coast. Lots of good info.