CL 77 Cam Chain Tensioner Pin Movement

uadmlj1 · Post by **uadmlj1** » Thu Oct 13, 2011 10:15 am

Once the retaining bolt is loosened, how much in/out movement should there be in the pin as you rotate the engine? Mine is maybe only 1/4 inch.

davomoto · Post by **davomoto** » Thu Oct 13, 2011 12:34 pm

Sounds about right. Tighten the locking bolt when it's the furthest in.

Davo

uadmlj1 · Post by **uadmlj1** » Thu Oct 13, 2011 12:43 pm

Thanks DAVO. 2008 posts. impressive.

davomoto · Post by **davomoto** » Thu Oct 13, 2011 2:12 pm

Thanks! It's taken 5 years to rack them up! Maybe I shoud stop at 2011?

Davo

s2000erick · Post by **s2000erick** » Thu Oct 13, 2011 6:44 pm

Don't even think about it! I don't post much because I don't know much. Thanks for your contribution comments. I read them all at least once, some even more!

s2000erick · Post by **s2000erick** » Thu Oct 13, 2011 6:44 pm

Don't even think about it! I don't post much because I don't know much. Thanks for your contribution comments. I read them all at least once, some even more!

Hotshoe · Post by **Hotshoe** » Thu Oct 13, 2011 11:04 pm

You could stop at 2012 in solidarity with the doomsday crowd ;}.
Seriously though, +1 on the thanks for your help Davo, always appreciated.

Honda305.com Forum

CL 77 Cam Chain Tensioner Pin Movement

CL 77 Cam Chain Tensioner Pin Movement

Thanks

Stop at 2011

Stop at 2011