CA78 Dream Handlebars

bbap · Post by **bbap** » Wed May 11, 2011 7:31 pm

Can anyone advise me if these bars would fit my bike. They do not say they are for a CA78 305 Dream, but they look the same. I've got the slide style throttle control. Here's the link on ebay:
http://cgi.ebay.com/ebaymotors/HONDA-TO ... ccessories

Frame and engine number below. Mine are a mess. Thanks! Steve

OldStan · Post by **OldStan** » Thu May 12, 2011 10:03 am

I think the main difference is the CA77 bars are more swept back. From the parts manuals the throttle pipe and lever mounts are the same. The only other problem could be the width of the center where it mounts. Maybe someone with at CA160 can give that measurement.

My bars are also a mess (typical bent on right and bad chrome), so I'd like to know too.

wnbasac · Post by **wnbasac** » Thu May 12, 2011 11:51 pm

hey be careful with this seller
>
i bought these bars because they have the OEM winker holes in them and tried to contact the seller when i didn't hear anything, the reply stated that he was away ( hondaism is out of the office until 01/31/2014 and may not be able to respond to your message )
>
i had e-bay look into it and someone replied from his end stating ( sorry it's ran uot of stock will refund ok thnx- hondaism )
>
e-bay got me a refund
>
just and FYI

bbap · Post by **bbap** » Fri May 13, 2011 6:38 pm

Thanks for the headzup....I sent them an email and it indicated pretty much the same. No contact which means I doubt I'll buy from them. Maybe I'll check their very recent feedback for a hint if they are still in business.