305 Head Gasket-What Caused This?

jcspc · Post by **jcspc** » Tue Sep 01, 2009 5:07 pm

I'm on board with ya davo. Just picked up some hondabond today, I'll order up my gasket and get to it. Thanks for you all's input. I LOVE this site and those who use it! Thanks again...

jcspc

davomoto · Post by **davomoto** » Tue Sep 01, 2009 5:56 pm

You're very welcome, and let us know how it goes.

davomoto

jensen · Post by **jensen** » Sat Sep 05, 2009 3:02 am

try this for a change :

91303-035-000

I ordered two, and I will came back with results

davomoto · Post by **davomoto** » Sat Sep 05, 2009 9:45 am

S65 cyl to head seal. I am very familiar with them. I have a buch, and see what the fit look like. They are flat, not an o-ring, definately much thicker than the stock o-rings.

davomoto

jensen · Post by **jensen** » Sat Sep 05, 2009 10:13 am

and are heat resistant, oil resistant and can take the pressure

jcspc · Post by **jcspc** » Sat Sep 05, 2009 12:54 pm

Yeah but under compression, will they fill the space too much and force the gasket apart?

jcspc · Post by **jcspc** » Sat Sep 05, 2009 12:57 pm

I just noticed... I got a lot of "yeah but" s... Hmmmmm...