stud install

Dana01 · Post by **Dana01** » Thu Jan 27, 2011 12:58 am

Hiyall,

This seems trivial, but ... I'll be trivial anyway.

I'm about to install 2 replacement studs into the upper trans case. Do I use anti-seize, thread lock, or nothing? And no I don't plan on removing them anytime soon.

Goodysnap · Post by **Goodysnap** » Thu Jan 27, 2011 6:56 am

If anything I think I would use blue thread locker. Seals the threads from corrosion and they dont work loose, yet still removable later. I dont care for antisieze on threads.

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Jan 27, 2011 7:16 am

The studs have a top/bottom so compare the new ones to those already installed. (thread depth is different on each end)
Install them with a small amount of oil so they will install easily to the last thread.
Not necessary to over tighten as ya will not have a problem with them coming loose/out.
Just what I do. ................lm

Dana01 wrote:Hiyall,

This seems trivial, but ... I'll be trivial anyway.

I'm about to install 2 replacement studs into the upper trans case. Do I use anti-seize, thread lock, or nothing? And no I don't plan on removing them anytime soon.

Dana01 · Post by **Dana01** » Thu Jan 27, 2011 5:22 pm

thanks guys!

Honda305.com Forum

stud install

stud install

Re: stud install