CA and CB parts

conbs · Post by **conbs** » Mon Jan 17, 2011 6:06 pm

1. I have a good CB carb body, but need all of the brass parts inside and the slide/spring/top cap. Maybe someone has a carb with a broken mounting flange or something.

2. The 2-wire harness that attaches to an early Dream coil. About 6" long.

Thanks for any help.

G-Man · Post by **G-Man** » Tue Jan 18, 2011 12:37 pm

Which CB - 72 or 77 ?

Which carb - left or right?

I'll have a look in my parts.

G

conbs · Post by **conbs** » Tue Jan 18, 2011 4:55 pm

G-man, I have a left carb body so I just need all the brass insides, including the float and listed top parts which I thought were the same on both sides. CB77.

Thanks for looking.

davomoto · Post by **davomoto** » Wed Jan 19, 2011 9:27 am

Top cap and slide are different for each side.

Davo

Andy's CB · Post by **Andy's CB** » Wed Jan 19, 2011 9:54 am

my sliders have an "r" or "l" on the part facing up when installed in the carbs, assume its right and left, thats how they fit anyway haha...i have one but i cant get it out of the carb. been sitting for ages and ages....

conbs · Post by **conbs** » Wed Jan 19, 2011 11:39 am

Thanks for the info Davo and Andy.

If I had only taken a minute to think, the slides would have to be left and right so the slot for the idle screw would be to the outside on both sides. When I ASSume...... Okay, in this case it was just me.

Top caps different, too? Is that to accomodate the cable fitting into the slide?

davomoto · Post by **davomoto** » Wed Jan 19, 2011 6:53 pm

Top caps are different in that they angle the cables towards the frame.

Davo

Honda305.com Forum

CA and CB parts

CA and CB parts

CB carb

Slide side