cb 77 engine stuck???

LOUD MOUSE · Post by **LOUD MOUSE** » Wed Oct 13, 2010 9:57 am

What in the world????????????.
Also thanks for the pics. Have an of the filter and chain and outer clutch basket?. .........lm

waynew wrote:L M i have taken some digital pictures and am now going to try to figure out how to post them. the screws you mentioned are in the shifter area (how did u know that?) but the other 6 screws i removed from the c-case cover were phillips head.

waynew · Post by **waynew** » Wed Oct 13, 2010 10:03 am

L M are you asking if i have a pic of the oil filter, chain, etc?

LOUD MOUSE · Post by **LOUD MOUSE** » Wed Oct 13, 2010 10:39 am

Yep.
If ya can will ya show all the parts which show damage and the loose screws also.
Will the engine turn over now?. ........lm

waynew wrote:L M are you asking if i have a pic of the oil filter, chain, etc?

waynew · Post by **waynew** » Wed Oct 13, 2010 10:58 am

L M, the only damaged part i've found thus far is the area where the oil filter shaft goes into the c-case (as shown in the 2 pictures). Oil filter, chain, etc. seem fine. I have not accessed the clutch area yet due to 2 p-h screws that are gouged-out in the c-case cover. as far as "loose" screws i've not come across any of them YET!

davomoto · Post by **davomoto** » Wed Oct 13, 2010 11:07 am

Wayne, a good way to remove those stripped screws is with a center punch. Hit the punch straight into the screw head until you make a nice divot. Then slowly angle the puch more asnd more, until the screw breaks loose. Obvoiusly the screw is trahed at this point, but it was shagged already anyway.

waynew · Post by **waynew** » Wed Oct 13, 2010 11:12 am

Thank you sir. I'll give that trick-a-try.

LOUD MOUSE · Post by **LOUD MOUSE** » Wed Oct 13, 2010 11:15 am

I misread a previous message about the screws. ...............lm

waynew wrote:Thank you sir. I'll give that trick-a-try.