Carb. needle settings

sstaylor · Post by **sstaylor** » Sun Jul 30, 2006 9:48 pm

I have rebuilt and re-installed the carbs on my '67 CB77. Now I need some help with adjusting the needles. What should they be set to from fully closed?

TIA,
Scott

joeweir1 · Post by **joeweir1** » Wed Aug 02, 2006 6:45 pm

I know on the CA77 single carb unit you should start with the air screw at 3/4 to 1 1/4 turns out from closed.Idle screw set until it just starts to touch /move the slide.There is a set up procedure for these here on this site somewhere in the FAQ's section I believe that is of more help for the CB's and CL's.

sstaylor · Post by **sstaylor** » Thu Aug 03, 2006 5:18 am

Joe,

Found it in FAQ. Thanks for the tip!

Scott