case punched

joeweir1 · Post by **joeweir1** » Fri May 21, 2010 11:40 am

Anyone see a case with punch marks before that were put there to I assume to hold seal in?Photo is alittle blurry but you can see them around the seal.

LOUD MOUSE · Post by **LOUD MOUSE** » Fri May 21, 2010 11:47 am

That was/is used as ya say to hold the seal in place.
Not a HONDA engine item when the bike was issued for sale. ..........lm

joeweir1 wrote:Anyone see a case with punch marks before that were put there to I assume to hold seal in?Photo is alittle blurry but you can see them around the seal.

joeweir1 · Post by **joeweir1** » Fri May 21, 2010 9:00 pm

LM-Was this a common practice? This was the first time I had seen this on the 4 or 5 engines I tore apart.

LOUD MOUSE · Post by **LOUD MOUSE** » Fri May 21, 2010 9:12 pm

Nah!
I've seen it a couple of times.
One of those MYTHS as to what needed to be done in the time!. .............lm

joeweir1 wrote:LM-Was this a common practice? This was the first time I had seen this on the 4 or 5 engines I tore apart.

Honda305.com Forum

case punched

case punched

Re: case punched