noisy motor after warm-up

[vanquire]

Hey Sparg - thanks and thanks! Shooting with a Canon EOS-1ds.( An older pro digital) w/ 100mm lens that makes for short focus.

I read the reference thread and went straight to my parts manual and found the carb's exploded view does show the overflow tube. I think its just a safety thing...

Here's a shot I did of a Dream I used to own. Bought it in Virginia and sold it to a gal in Canada! I used to sell this poster on eBay as a limited edition print.

I know, I know... this is the CB77 column!!!

[LOUD MOUSE]

Where in the parts book do tou find the tube?. .......lm

Hey Sparg - thanks and thanks! Shooting with a Canon EOS-1ds.( An older pro digital) w/ 100mm lens that makes for short focus.

I read the reference thread and went straight to my parts manual and found the carb's exploded view does show the overflow tube. I think its just a safety thing...

Here's a shot I did of a Dream I used to own. Bought it in Virginia and sold it to a gal in Canada! I used to sell this poster on eBay as a limited edition print.

I know, I know... this is the CB77 column!!!

[vanquire]

Hey there lm,

I noticed it on page 46, E-14, Left Carburetor. Its kinda lost on the page. But in the upper left of the exploded view there is the assembly view - labeled #1. See attached scan...

But I have seen Hawks without them too. I'm not sure what to think...

Is there a way to post a small movie file or sound bite? Maybe you can get a better idea of what may be causing my engine noise?

Thanks!!!

[LOUD MOUSE]

That is a brass tube which is part of the atmosphere balance in the carb to allow gas to flow to a certain level and speed. No other tube is shown attached to it. .............lm

Hey there lm,

I noticed it on page 46, E-14, Left Carburetor. Its kinda lost on the page. But in the upper left of the exploded view there is the assembly view - labeled #1. See attached scan...

But I have seen Hawks without them too. I'm not sure what to think...

Is there a way to post a small movie file or sound bite? Maybe you can get a better idea of what may be causing my engine noise?

Thanks!!!

[Gunner_CAF]

...Is there a way to post a small movie file or sound bite? Maybe you can get a better idea of what may be causing my engine noise?

Thanks!!!

You may need to use a free file hosting site. I use box.net or savefile.com.

Gunner

[vanquire]

Thanks again for the great info! And I will work on getting the sound bite available this week...

~Van

[Sportscub]

My Honda Dream is noisy to.
Runs and starts great. 30000km. But just like you say it sounds like valves hitting the pistons.
Only sometimes with the somewhat higher revs.
I know my tensioner has been worked. But... I think if it was the camchain then you should hear it on the lower revs.

Anybody with the same experience?