Top Cover Breather Tube

Wilf · Post by **Wilf** » Sun Mar 15, 2009 7:03 pm

My CB77 had no breather tube on the top cover and before putting the coils back in I thought I would replace the breather tube. After searching the posts this morning I know from the photo that the tube runs down under the crankcase cover plate, but I don't know where it finally ends up. Would someone clue me in please?

Thanks

sixtiescycles · Post by **sixtiescycles** » Mon Mar 16, 2009 7:24 am

It makes a 90 degree bend, goes under the latch bracket and out the the hole below the alternator wires where it then terminates.
Dick

Wilf · Post by **Wilf** » Mon Mar 16, 2009 9:02 am

Thanks Dick, that is exactly what I needed to know. I imagine having a half inch or so protruding from the hole would be appropriate?

Wilf

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Mar 16, 2009 9:31 am

As long as it doesn't run on the sprocket. .................lm

Wilf wrote:Thanks Dick, that is exactly what I needed to know. I imagine having a half inch or so protruding from the hole would be appropriate?

Wilf

Wilf · Post by **Wilf** » Mon Mar 16, 2009 10:20 am

Thanks for the caution, LM.

Wilf

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Mar 16, 2009 10:23 am

Ya welcome. .............lm

Wilf wrote:Thanks for the caution, LM.

Wilf