Houston 1966 305 Dream Log

joeweir1 · Post by **joeweir1** » Sun May 11, 2008 7:37 am

I ended up soaking a different carb. and putting that on and left the original parts in it at first.Then both plugs were fouling and I ended up putting the clip on the needle at the second notch from top.I then put a 125 main in it and it has run fine since.

LOUD MOUSE · Post by **LOUD MOUSE** » Sun May 11, 2008 8:15 am

Compression test? May I recommend when you check the valves on the bad side that you remove the adjuster screws and check for FLAT SPOTS on the face end. If you find any a piece of 600 wet or dry can be drawn across the end in an arc to dome the end again and when you adjust the clearance you will be spot on. .................lm

Bob Dale wrote:I have not checked them recently but the insulator was fine last time I had the carb off and the o'ring was replaced when I rebuilt the carb. I'm pretty sure there's no air getting around it if thats what you are suggesting. I just dont see how that would cause fouling on one side worse than the other unless the air current enters at a sharp angle, sending more air towards 1 side of the engine than the other?

joeweir1 · Post by **joeweir1** » Sun May 11, 2008 10:56 am

LM-I was wondering if those could cleaned up alittle or best to just buy new ones if available.I'll have to try that on some extras laying around.

LOUD MOUSE · Post by **LOUD MOUSE** » Sun May 11, 2008 11:08 am

Not that hard to do if you take your time.
HONDA is out of them. .................lm

joeweir1 wrote:LM-I was wondering if those could cleaned up alittle or best to just buy new ones if available.I'll have to try that on some extras laying around.

joeweir1 · Post by **joeweir1** » Sun May 11, 2008 7:32 pm

Thanks

Bob Dale · Post by **Bob Dale** » Sun May 11, 2008 8:30 pm

Compression checks out the same on both sides, although it does seem low at 90psi. I havent checked the valve gaps lately but I did look for flat spots before installing them a few months ago. I think they tappets are fine but may need adjusting.

On a completely unrelated topic, I have pulled the front wheel to clean it up before my new tires arrive this week and plan to repack the bearings before putting it back together. I notice that there are 2 rubber seals, 1 on each side of the axle, for retaining the grease. They appear to be in good condition but I did have a LOT of grease accumulation on the outside of the speedo sending unit. There is also what I would call a ribbed o-ring around the outside of the speedo sending unit housing. Can these seals be replaced? The dont come out easily and I dont want to destroy them if I wont be able to find replacements.

Durangoman · Post by **Durangoman** » Sun Apr 19, 2009 12:46 am

11 months, Time for an update..