RH Crankcase clutch adjuster grease/clutch rod seal '66 CB77

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Jun 09, 2017 10:03 am

If you have the original filter ya can cut the tube from it (cut about 1/4 in. around) and JB Weld it to the new filter at the same location. .....................lm

Tropicalpunchai wrote:Thanks, Tim!

Glenn-N · Post by **Glenn-N** » Fri Jun 09, 2017 10:22 am

Good point about the dirt Ed.

I'll mount it behind the airfilter, same place where the wire harness sits.

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Jun 09, 2017 10:26 am

As AIR GOES INTO the tube NOT OUT you may want to just put a tube between the 2 nipples on the head. .............................

Glenn-N wrote:Good point about the dirt Ed.

I'll mount it behind the airfilter, same place where the wire harness sits.