Cure for oil leaks from head?

Vince Lupo · Post by **Vince Lupo** » Fri Feb 19, 2010 9:52 am

Many thanks for putting my mind at ease -- I need all the help I can get!

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Feb 19, 2010 10:44 am

Ya Welcome. .........lm

Vince Lupo wrote:Many thanks for putting my mind at ease -- I need all the help I can get!

DONZIE · Post by **DONZIE** » Sat Feb 20, 2010 11:25 am

Emo I ain't never seen one these heads leak have only heard about them. I sure would hate to pull a good head just for that reason. What about some kind of "sealing washer" in the place of the normal spark plug washer, bet I could make one !

LOUD MOUSE · Post by **LOUD MOUSE** » Sat Feb 20, 2010 3:56 pm

The leak is between the cast aluminum and steel head cap and there's no place to put a washer to stop the oil. ..........lm

DONZIE wrote:Emo I ain't never seen one these heads leak have only heard about them. I sure would hate to pull a good head just for that reason. What about some kind of "sealing washer" in the place of the normal spark plug washer, bet I could make one !

DONZIE · Post by **DONZIE** » Sat Feb 20, 2010 4:41 pm

The leak is just around the spark plug though right? Where the cast iron & the aluminum meet
I'm asking cause I've never seen one leak

LOUD MOUSE · Post by **LOUD MOUSE** » Sat Feb 20, 2010 4:46 pm

That's correct.
The 2 parts separate at that area. ...................lm

DONZIE wrote:The leak is just around the spark plug though right? Where the cast iron & the aluminum meet
I'm asking cause I've never seen one leak

DONZIE · Post by **DONZIE** » Sat Feb 20, 2010 4:55 pm

That's what I thought. I was just thinking of those thin flat washers with a neoprene gasket bonded to them like used on a metal building screw. Their are some about 3/4" od or so.

Honda305.com Forum

honda305.com Forum

Cure for oil leaks from head?

EMO

Re: EMO