Intake and Exhaust Valves, Swingarm bushings, Points Cam

[Dickj]

I need to locate Intake and exhaust valves for my 1966 CL77 Scrambler. Any suggestions??

I'm also looking for 2 new swingarm bushings for lower rear shock clevis. I had the old ones pressed out and one was OK but the other one was destroyed.

I also need a Points cam for the same engine. Mine is rough and corroded and the mechanic is afraid the seals will wear out fast.

I searched E-bay and other sources but came up dry.

Thanks, Dick J Santa Rosa. CA

[Hoosier Tom]

http://www.ebay.com/itm/Honda-CB77-CL77 ... 19bf8cfb4d

http://www.ebay.com/itm/Honda-CB77-CL77 ... 5d29b7d27d

You'll have to make sure to measure your points cam shaft diameter to get the proper one as there are 2 different ones.

I also found plenty of listings for CB77/CL77 valves.

HT

[conbs]

Check for posts by LM on the valves. If I recall correctly he strongly recommends using Honda valves, but I can't remember exactly why.

[LOUD MOUSE]

I sent a PM to ask why "New Valves.
So far no reply. ............lm

Check for posts by LM on the valves. If I recall correctly he strongly recommends using Honda valves, but I can't remember exactly why.