Connecting rods

Jefft · Post by **Jefft** » Wed Nov 21, 2018 7:07 pm

I’m in the process restoring a couple of CB77 and need a couple of decent connecting rods to work with. I’m prepared to modify them to use oversize pins but I want to start with the best pieces I can find.( no rust and salvageable.) let me know what you have. Any help would be greatly appreciated.

G-Man · Post by **G-Man** » Thu Nov 22, 2018 2:51 am

Jefft

They come up on eBay occasionally. I am rebuilding many CB/CL/CA77 and found two sets in a box of rusty parts recently in a barn full of parts in UK.

I don't know if I'll have any spares for the forseeable future but, if you are patient, you'll find something.

These rods were re-claimed in my workshop by bushing the small-ends.

G

Jefft wrote:I’m in the process restoring a couple of CB77 and need a couple of decent connecting rods to work with. I’m prepared to modify them to use oversize pins but I want to start with the best pieces I can find.( no rust and salvageable.) let me know what you have. Any help would be greatly appreciated.

Seadog · Post by **Seadog** » Thu Nov 22, 2018 9:38 am

I wonder if it’s possible to convert the con rod ends to use needle bearings? Is there enough material?

Jefft · Post by **Jefft** » Thu Nov 22, 2018 9:50 am

How thick will your small end bush be? The small ends are not very big so there is not a lot of material to work with. Let me know what your plan is and I may bush mine.

Seadog · Post by **Seadog** » Thu Nov 22, 2018 9:58 am

Jefft wrote:How thick will your small end bush be? The small ends are not very big so there is not a lot of material to work with. Let me know what your plan is and I may bush mine.

I'm just being curious, Jeff. I don't have the facilities to machine for bushings or bearings.

G-Man · Post by **G-Man** » Thu Nov 22, 2018 1:01 pm

Seadog

Not really enough room and not often done in four strokes because of the high loads.

G

Seadog wrote:I wonder if it’s possible to convert the con rod ends to use needle bearings? Is there enough material?

G-Man · Post by **G-Man** » Thu Nov 22, 2018 1:02 pm

Bushes are 0.5 mm wall thickness when finished. I make a thick bush, press it in then finish bore in situ.

G

Jefft wrote:How thick will your small end bush be? The small ends are not very big so there is not a lot of material to work with. Let me know what your plan is and I may bush mine.

Honda305.com Forum

Connecting rods

Connecting rods

Re: Connecting rods