Carb part needed.

CL77butcher · Post by **CL77butcher** » Mon Apr 18, 2011 11:46 am

I need a float bowl for a 68 CL77 kei-hin carb, mine had a pin hole that I re-flowed with silver but the heat warped the bowl and I don't think it will last long. Please help, I don't want to buy a whole carb over a warped bowl. :)

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Apr 18, 2011 12:09 pm

DANG!!!!!!!!!!!!!!!
I misread and thought all he needed was a float.
J.B. Weld will fix the bowl. ................lm

These folks have them cheap. .......lm

<http://www.olypen.com/retro/>

CL77butcher wrote:I need a float bowl for a 68 CL77 kei-hin carb, mine had a pin hole that I re-flowed with silver but the heat warped the bowl and I don't think it will last long. Please help, I don't want to buy a whole carb over a warped bowl. :)

Snakeoil · Post by **Snakeoil** » Mon Apr 18, 2011 1:34 pm

For future reference, you cannot solder on carbs, Butcher. You can fix pin hole with an epoxy. Make sure it is epoxy and not polyester resin. You should make a test sample and soak it in modern gasoline first to see if it will be affected by the fuel.

The carbs are either aluminum or zamac, which is a zinc alloy.

regards,
Rob

Dana01 · Post by **Dana01** » Mon Apr 18, 2011 3:46 pm

Local hobby stores have fuel-proof (nitromethane) 2-part epoxy made for RC applications. I like "Hobby Poxy" ... comes in a variety of setup times.

Honda305.com Forum

Carb part needed.

Carb part needed.

Re: Carb part needed.