wanted- long shift linkage shaft

scum · Post by **scum** » Mon Dec 31, 2007 8:04 am

Does anyone have an extra shift linkage rod ? I'm looking for the long one that is used when the pegs are installed on the rear most position. Thanks.

davomoto · Post by **davomoto** » Tue Jan 01, 2008 12:47 pm

scum, I made my own. I used 1/4 inch rod ends, and 1/4 steel rod. I threaded it myself, or you can get threaded rod, and sleve it to clean up the look. Rod ends are around 2.00 each. I have all the stuff to make more if you want one made.

davomoto

LOUD MOUSE · Post by **LOUD MOUSE** » Tue Jan 01, 2008 6:44 pm

Ya want HONDA od make your own?. ................lm

scum wrote:Does anyone have an extra shift linkage rod ? I'm looking for the long one that is used when the pegs are installed on the rear most position. Thanks.

scum · Post by **scum** » Thu Jan 03, 2008 5:09 pm

thanks man. I'll prob'ly make one up.

bbraun · Post by **bbraun** » Thu Jan 03, 2008 8:32 pm

I made mine too; used an extra engine stud; already threaded on one end; cut off and cut reverse threads on other end and you're done!
Beth

Honda305.com Forum

wanted- long shift linkage shaft

wanted- long shift linkage shaft

Re: wanted- long shift linkage shaft