Need header pipe mounting bolts/skrews!

newcb77owner · Post by **newcb77owner** » Fri May 27, 2011 3:37 pm

I have the headers, the spacers, the gaskets, and the 2 mounts. BUT I do need the 4 bolts that are needed to secure them all to the engine. Please if you have and extra set, let me know. Or the size needed.

Thanks, Dan

davomoto · Post by **davomoto** » Fri May 27, 2011 6:20 pm

6mm x 28mm stud is what the online fische says it requires. Most hardware stores have a small selection of metric studs, or you could use bolt of the correct leng. 6mm x 1.0 is the thread diameter and pitch.

Davo

newcb77owner · Post by **newcb77owner** » Sat May 28, 2011 3:32 pm

Hey thanks for the info!
so what your saying it that the thread pitch is 6mm x 1.0? i don't care for length as long as i can skew em tight.

thanks again!

davomoto · Post by **davomoto** » Sat May 28, 2011 4:05 pm

Yes, 6mm x 1.00