Early 1963 CA77 Shipping Question

[SteveAllenHonda]

Hi, I need to ship an early 1963 CA77.To prevent an "oversize" rate on UPS for the frame my ?-is the rear fender section welded at the seam or is it held together by the rear shock mount brackets? Also-the weight of the engine only? Thanks in advance.

Steve

[LOUD MOUSE]

I think it is spot welded.
The engine is APX 130 lb. with starter.
"I THINK". ...................lm

Hi, I need to ship an early 1963 CA77.To prevent an "oversize" rate on UPS for the frame my ?-is the rear fender section welded at the seam or is it held together by the rear shock mount brackets? Also-the weight of the engine only? Thanks in advance.

Steve

[jkv357]

Hi, I need to ship an early 1963 CA77.To prevent an "oversize" rate on UPS for the frame my ?-is the rear fender section welded at the seam or is it held together by the rear shock mount brackets? Also-the weight of the engine only? Thanks in advance.

Steve

Yes. It does not unbolt.

[SteveAllenHonda]

I think it is spot welded.
The engine is APX 130 lb. with starter.
"I THINK". ...................lm

Hi, I need to ship an early 1963 CA77.To prevent an "oversize" rate on UPS for the frame my ?-is the rear fender section welded at the seam or is it held together by the rear shock mount brackets? Also-the weight of the engine only? Thanks in advance.

Steve

Thank You for the information.

Steve

[LOUD MOUSE]

You are welcome Steve. ....................lm

I think it is spot welded.
The engine is APX 130 lb. with starter.
"I THINK". ...................lm

Hi, I need to ship an early 1963 CA77.To prevent an "oversize" rate on UPS for the frame my ?-is the rear fender section welded at the seam or is it held together by the rear shock mount brackets? Also-the weight of the engine only? Thanks in advance.

Steve

Thank You for the information.

Steve