washer placement?

foosneb · Post by **foosneb** » Wed May 04, 2011 9:45 am

First off I apologize if this has already been discussed in other threads......in fact I know it has. So I guess I'm asking for clarification. The washer pictured below is placed on the end of the filter shaft between filter and case.......this is where it was located upon removal. From searching, it is suggested it should be between filter and outer cover?
Thanks
Jon

foosneb · Post by **foosneb** » Wed May 04, 2011 11:15 am

Nevermind, I found my answer.
Next time I'll search a little bit harder before clogging up the forum with redundant questions.
Sorry guys.

Dana01 · Post by **Dana01** » Wed May 04, 2011 5:51 pm

No worries Jon, the question may be redundant, but the pic is perfect. Mine came the same way.