Gearbox Bearings

AlanW · Post by **AlanW** » Wed Sep 28, 2016 10:38 am

LM is correct, if you are still unsure feel free to contact me, I only live a few miles away from you.
Al.

Yedar · Post by **Yedar** » Wed Sep 28, 2016 4:18 pm

Thanks for the info everybody, I had stripped the gearbox to replace the 14mm bush & on re assembly I noticed that the final drive ball bearings did not move straight away when I spun the mainshaft, this made me think all was not as it should be. I considered Loctite but then
how could I ensure the bearings would locate the upper crank case collars, in the end I decided to just go with it as was working before.
Hi AlanW from the Wirral I don't know how to contact you other than through this forum.
Cheers Richard.

honda brian · Post by **honda brian** » Wed Sep 28, 2016 4:55 pm

Thanks Ed for a better answer than mine. The ball bearings will take the path/area of least resistance which is of course, their rolling path/area.
Brian.

AlanW · Post by **AlanW** » Thu Sep 29, 2016 3:42 am

Hi Richard, send me a PM via the forum and we can take it from there.
Cheers Al.

Honda305.com Forum

Gearbox Bearings

gearbox bearing

gearbox bearings