Exhaust crush gasket

Jethro · Post by **Jethro** » Mon May 23, 2011 7:54 pm

The crush washers that I got in my gasket kit are slightly bigger than the holes they go into. Should I have to press them in? I guess I figured they would just push in without too much effort. Anyone experienced this?

48lesco · Post by **48lesco** » Tue May 24, 2011 9:42 pm

Yes - The aftermarket ones don't always fit so well. Those are still available from Honda.

dlobby12 · Post by **dlobby12** » Fri Jul 01, 2011 10:21 pm

are these washers copper I wasn't sure where they went

Honda305.com Forum

Exhaust crush gasket

Exhaust crush gasket

crush casket