Honda305.com Forum

I have a 1966 CA-77 where the crankcase cover with new gaskets, leaks. I have tried 3 !!! gaskets, the first two attempts I used Permatex gray. I took the cover and carefully rotated it on a 1/4 thick glass shelf, marked it with an marker pen, and sanded until it was smooth. The two guide pins are t...

I have a 1966 CA-77 305, I had to take my crankcase cover off to access the clutch, and upon placing it carefully back on with a new gasket, it leaked. I never had a leak before. I spoke with the Motorcycle shop about it, assuming since they were handmade by this shop, and that I never had a leak, t...

I have a 66 305 Dream, and wanted to know if there is a forum on how to adjust the front and rear brakes?
Where the proper angle to start off with, on the levers "even before you turn the brass 14mm nut?

Thanks

In order to clean the plates, any suggestions on how or what to be careful with in this cleaning process?
A certain procedure? Do I soak them in a pan ? and with any particular cleaning fluid or?
or just separate them and rub them with a cloth? etc.

Thanks

I warmed up bike, had running on center stand, had great difficulty to get it into 2,3, and 4th (crunching) when in 4th gear, seeing back wheel turning, put rear brake on , saw rear wheel stop, and then at same time the engine immediately stop! So why I dont know.

Thank you for helping. am not clear on the method? 1st I will let the bike idle for lets say 5 minutes or so? to warm up 2. then Im not clear , should I start it in 4th gear which I would think is not possible? or do you mean start it while on the center stand, then click it to 4th ?and let it run w...

Hi Fellow Vintage Honda lovers, This is my first entry into the Honda forum, which I am excited to be part of, and share this common appreciation for these great motorcycles. I have had my 66 CA-77 since the 80's, and enjoyed it in the condition I purchased it in. I last drove it in 2009 as I moved ...