Honda305.com Forum

I believe it is an attempt to put the post back on top ahead of all the spam.

Keihin Thread Sizes Drain Screw_____________M6 X .75 Slide Stop Screw________M6 X .75 Idle Air Screw__________M6 X .75 Main Jet________________M5 X .9 NeedleJet Holder________M8 X 1.0 Float Needle Seat_______M9 X 1.0 Cable Adjuster__________M8 X .75 Pilot Jet_______________M4.5 X .75 Fuel Inlet_____...

Hi Seadog
The sliding gears had six engaging dogs while the fixed gears had three. Is that what you are seeing?

Very nice!

I believe it was Ellis Holman.

The crank sprocket is 15 and the clutch sprocket is 47 giving a 3.13 reduction.

I looked at your disassembled carburetor picture and can't tell for sure if the slide is right. The low speed air enters through the radius cut on the slide and it must be facing toward the air filter. If the slide is not correct the engine will run crazy rich on low end and can run well after it ge...