Honda305.com Forum

im trying to figure out whats up with the fenders here. every dream i see in forums and when i google em have the full fenders. these seem chopped.


dream2 by nmackey, on Flickr

that 62 hawk turned out to be a beauty. I dont have nearly as much work to do to mine. Gives me hope for the dream.

It helps alot knowing i can get most of my nuts and bolts at the hardware store. i have a bunch that just arent there so ill have to go through the clymers manual or start asking questions to get some of the right sizes. Your info is helping alot though. Its nice to know i have the forums to turn to...

Frame number #1001779
engine CB77E #1005354

Any ideas?

thanks for all the info advmax. This is going to be a daily driver for me when weather permits. If going stainless is better, than thats what ill do. Do you have info on the best place to get everything from? I know its gonna be a patience test with some of this for me. I guess ill be learning alot ...

mine isnt quite that bad. It turns with my socket set but it just wont come out. I did tap on it a bit and it came out about a qusrter to half inch. i have a feeling ill need to use a clamp vise to push and find a way to pull it out. Its the only way i can think of. I tried searching posts , but to ...

finally getting down to the frame. swingarm and forks are going to be new to me. Any info on removing the swingarm would be helpful. I cant get it to budge and i dont want to smash the nipple on the end of the nut side. Not sure of the best way to do this.