Honda305.com Forum

Got this dream awhile back and the previous owner had this exhaust on it. It's too load for me, and I'm sure it would do the bike some good to have a little back pressure. However, I've tried and tried to find some baffles, and can't identify the pipes. Any idea on what I could do?

(SIGH!!!) Thanks LM. I get a little paranoid sometimes. I did notice the points were different than on my 250. Also, what do you think would cause the timing to be so far off? I only tested it while running, not the static test. WAY advanced, and I couldn't move the points plate far enough to correc...

Just bought a 66 305 dream yesterday. Rode it back about 110 miles and it was a little under powered. It just wasn't running right. It would stutter through the throttle, and I was only able to get up to about 70mph. Tank was rusty inside, so that needs cleaned obviously, along with the carb. Howeve...

I need some help in a purchase. Fella I know has a cb77 that supposedly has a really strong motor, new pistons and rings bored 50 over, but the rest of the bike is REALLY rough. Like as rough as possible with still being able to roll down the road. Thought about a total restore, but maybe just the m...

Currently have a 63 ca72 that I got running and love the bike to death. However, I was a little disappointed that it couldn't hang with traffic on the highway. Meanwhile I ran into a cb77 that's bored out 50 over with new pistons and rings and supposedly runs good, but the rest of the bike is really...

Ur a GENIUS! Pulled out the timing light and tried to see where it was firing and I guess when I put the plate back on it changed the timing 'cause it was about 30 degrees retarded. Adjusted, and "ROOOOM". But of course it wasn't going to stop there. After riding for a few minutes it loses power, th...

NICE CALL ON THE FUSE!!! Old wire was pretty nasty, so I changed it out, and BINGO! POWER! But I set the gap back to 14 on "II" and it acts like it doesn't want to start. just coughs and puffs but no run. I held it on "II" and with the switch on I slid the feeler gauge it and my other hand accidentl...