Honda305.com Forum

I have a new kickstarter arm, but there is nothing to grip on the worn spline. Have been looking for the new part for a while and it's the last thing to complete the project. Would appreciate the opportunity to buy one or advice on how to repair if possible. Thanks.

Does anyone know where I can get a 15T front sprocket for my CB77?
I can't find one so far and bought a 13T, but the original locking plate is too big in diameter and contacts the chain, stopping it sitting down on the sprocket.
Didn't really want to drop too much ratio, either.
Thanks.

Good thinking, LM. They use the trading name of " a113ycat ". Considering how far away I am, you would think they would check what they were sending me. Very disappointing, as I was waiting for the last part in the drive chain. I have chain and front sprocket already. And my car broke down a few day...

Forgot to mention, it was "Your trash, my treasure" who sold this junk to me. An appropriately named trader, it seems.

This may be a warning to people who are as trusting as me. I rely on getting parts for my CB77 from Ebay mostly. Most deals and parts have been fine, apart from the occasional carb rebuild set that doesn't fit. Recently I bought a rear sprocket which looked good in the auction picture. When it arriv...

Davo My CB77 is a 1964. The bowls look square but where the gasket sits is curved rather than straight. Also the corners are round. Is this called square bowl or round bowl? Photo attached, please ignore Loctite aviation gasket cement, which will be cleaned off later. bbap I have bought stuff from ...

I also bought a set of these kits, so your warning came too late. I asked questions before purchase and was assured they had jets for both models of bike. There was no 135 jet for my 305, no needle for it and the gaskets did not fit. When I wrote to retromotorcycles, here's his reply:- " Hi I'm sorr...