Honda305.com Forum

Does anyone know where to get the two o-rings that go behind the oil filter cover? My service manuel says that the 65 honda dream is a large hole small hole design that uses #91309-000-010 (74.5x8mm) plus #91302-259-000(79.5x3). I know there are two o-rings so I think this is mine. My bike had a tin...

The pics help the only thing I did different than you was I put the pressure device on both pistons at the same time and used wood blocks at eight different locations. Since both rods are attached to the crank in the same place you cant move one piston much without getting a lot of resistance from t...

Looks great. If your pressing them out the hard part is now that the pistons are down as far as they can go because the crank is all the way down. What I have done is put wood blocks between the cylinder and the block and then continue with the pressing. The two I have done this year is soaked them ...

Great info I am going to take one apart tomorrow I will definitely use the sheet method. Do you start off by loosing the square nut on top. I broke down and bought the engine repair guide but that does not help me with the steering.

I spent the day out in the garage working on the bike and what I know is that the bike starts runs and drives fine for a 15 mile ride. What is does that I cant figure out and I have tried to figure out today is if the bike is on the stand and you kick the motor over it will start and run fine. If yo...

Degormley yes yes they are off.

Thanks again.

This summer I saw 85mph. I was passing traffic at a decent pace on a 65mph speed limit highway. but I've also been in a good head wind and can barley hang with traffic on the highway.