Honda305.com Forum

I seen one on eBay but not only is it $39.99 plus shipping it could take up 4 weeks to get here. I've managed to track down a pin at a local motorcycle place, but no one seems to have a roller. But if I can't get it I'll just have to wait for the part.

I'm in dire need of the cam roller guide and pin. Mine are just chewed up. Anyone have any ideas where I could get these?

The part numbers are:

ROLLER, CAM CHAIN GUIDE: 14611-250-310 (#13 on diagram)
PIN, CAM CHAIN GUIDE ROLLER: 14612-250-300 (#14 on diagram)

I had a piece of rubber and fitted it over the 20MM crankshaft nut and clamped down with a pair of vice grips.

Well, I finally just took a grinder too and sanded the "crack" off. It seems like it was just a casting flaw as it left no lines at all after some light sanding.

All in the same area?

I was breaking down the engine of my CA77 to rebuild it and examine anything that needed any attention and found this. I can feel it with my fingernail and I'm not a metallurgy expert so I don't know if this is a crack in the case or just a casting flaw. Have you seen anything like this? Should I ha...

Thanks, guys. I just found two tubes of it. The odd thing was I went to a Honda dealership and they sent me to a Mitsubishi dealership that had it.