Honda305.com Forum

Thanks Stan, that proved to be the right advice. The discs were frozen together. I took it all out, cleaned and lubricated it all and it shifted correctly thereafter. it is also surprisingly easy to work on this clutch. However, once I had it back together... the kickstarter no longer engaged. I bel...

1964 Honda Dream CA78, Philadelphia, PA I have tightened it to the fullest, I see full range of motion in the lifter at the end of the shift linkage, but once dropped into 1st or 2nd gear... there is no disengaging the clutch with the lever... it simply stays in gear/stalls out. I have read some of ...

thanks guys, i already rebuilt the carb... cleaned all the passages and put in new floats, needles, boot gasket, etc. and set the height BUT i actually think you may be right - that the float needle is sticking. Sometimes your brain sticks on something when you start assuming you're already past an ...

I finally got my dream project out of my basement. The gas will not flow through the carburetor while everything is hooked up. if I crack open the the float bowl a hair, the gas begins to flow... tighten it back down... it stops. Basically to me it reads as a tight/plugged carb... with no where for ...

brewsky hanging in for the long haul! just have to comb and comb and wait for a busted up one that has good parts... i'm a craigslist wizard. (allofcraigs.com) i got everything nearly sorted. except one minor issue: the neutral switch will not light unless the bulb is grounded to the frame... but wi...

well. some time has passed, other projects have come and go. now i finally have the dream back together and running beautifully. started on the first kick... the paint was all redone in gloss black BC/CC urethane. nothing was rechromed, just thoroughly cleaned. disassemble, clean, polish, paint and ...

Giving it a test run sounds reasonable. I will go with that. It seems to have been maintained well while it was in use and stored just fine. The tires were still properly inflated whitewalls. I bought all the manuals from a link I found on this site and enjoy going by the book. I'm 30 years old and ...