Freeing Frozen Pistons?

LOUD MOUSE · Post by **LOUD MOUSE** » Sat Sep 15, 2018 7:55 pm

The pic shows parts for a CB77. ??????????????????. ..............lm

modelman wrote:https://www.dropbox.com/s/6shchp9rexoch ... 1.jpg?dl=0

Nah, too far gone, I bought new replacements from your side of the pond!

modelman · Post by **modelman** » Sun Sep 16, 2018 2:50 am

And your point is???

The original post was 'Freeing frozen pistons'.

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Sep 16, 2018 5:37 am

Under the TITLES, CA72 | CA77 | CA78

modelman wrote:And your point is???

The original post was 'Freeing frozen pistons'.

modelman · Post by **modelman** » Sun Sep 16, 2018 11:26 am

Of course, what a dummy I am, CA & CB pistons & liners are COMPLETELY different.

Unbelievable.

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Sep 16, 2018 12:20 pm

The liners are the same but the pistons will cost you compression. ..............lm

modelman wrote:Of course, what a dummy I am, CA & CB pistons & liners are COMPLETELY different.

Unbelievable.

modelman · Post by **modelman** » Sun Sep 16, 2018 12:29 pm

Wont cost me any compression at all, My CA & CB each have the correct pistons,

but I thought we were talking about freeing pistons.

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Sep 16, 2018 12:56 pm

You were/are and so am I.
Check previous discussions on that subject and you may find a way to get the stuck pistons out with less time used and not the mess.
If you aren't open to when I see something I can help you with.
"JUST SAY SO AND YOU WILL BE HONORED"! ...............lm

modelman wrote:Wont cost me any compression at all, My CA & CB each have the correct pistons,

but I thought we were talking about freeing pistons.