Starter Rebuild

1941wld · Post by **1941wld** » Sun Oct 29, 2017 11:33 am

Any body out there have the sizes or part numbers on the o-rings used inside the CB77 electric starters?

Thanks,

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Oct 29, 2017 1:00 pm

Where are they installed?. ..lm

1941wld wrote:Any body out there have the sizes or part numbers on the o-rings used inside the CB77 electric starters?

Thanks,

1941wld · Post by **1941wld** » Sun Oct 29, 2017 6:10 pm

inside the CB77 electric starters

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Oct 29, 2017 6:23 pm

I rebuild those and can't thinkof a "O" ring.
More info?. ..........lm

1941wld wrote:inside the CB77 electric starters

1941wld · Post by **1941wld** » Mon Oct 30, 2017 6:24 am

brush inspection port
planetary gear housing

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Oct 30, 2017 8:20 am

I don't damage the inspection one.
HONDA didn't offer it as a replaceable part.
I add paper tape to the inside of the cover.
Same for the really thin paper seal.
I use a thin rubber band there. .............lm

1941wld wrote:brush inspection port
planetary gear housing

1941wld · Post by **1941wld** » Mon Oct 30, 2017 8:42 am

I've ordered a 60mm x 1mm o-ring for the planetary gear housing. It should squeeze down nicely. I'm going to measure the brush access port and find a new one that will work for it. I'll post my finding when finished.

Honda305.com Forum

Starter Rebuild

electric starter o-rings

Re: electric starter o-rings

o-ring

Re: o-ring

o-rings