Side cover trim

[cadman]

What's everyone using for the black trim around the side covers?

[rrietman]

basically there isn't any oem stuff. just monkey it up with hardware store as best you can. the buttons for the port side are easy. right side you need a thin strip glued in.
Good luck
Randy

[Gaius M]

i used 1/4 inch vacuum line (black) slit down one side.

[Seadog]

I used a windshield wiper blade, trimmed down to fit.

[bbap]

I used a windshield wiper blade, trimmed down to fit.

I cut out a piece of rubber out of an inner tube. Works and looks fine.

[Geoff Hastings]

What's everyone using for the black trim around the side covers?

This is what I used, it's actually a rubber gasket that is used on aluminium window frames, on the panel with the recess it just pushes in and on the side that usually has the two rubber pads I glued it in position. So, just ask a glazing installer, it cost next to nothing.

[G-Man]

Nice!

G

What's everyone using for the black trim around the side covers?

This is what I used, it's actually a rubber gasket that is used on aluminium window frames, on the panel with the recess it just pushes in and on the side that usually has the two rubber pads I glued it in position. So, just ask a glazing installer, it cost next to nothing.