mystery tank, for me that is.

Dream two · Post by **Dream two** » Thu Jan 05, 2017 2:14 pm

Could someone identify this tank for me?

http://www.ebay.com/itm/291860632868?_t ... EBIDX%3AIT

Thank you,
Rudy LI NY

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Jan 05, 2017 2:25 pm

I'd say it is what he says and has had the sides filled in/smoothed. ..............lm

Dream two wrote:Could someone identify this tank for me?

http://www.ebay.com/itm/291860632868?_t ... EBIDX%3AIT

Thank you,
Rudy LI NY

Dream two · Post by **Dream two** » Thu Jan 05, 2017 2:56 pm

Hmm, could well be, why is beyond me. What about the equal indentations, or created dents underneath?

Rudy LI NY

Dream two · Post by **Dream two** » Thu Jan 05, 2017 2:58 pm

What about the cap. Real weird and says" not vented" Probably a catch all that happened to Fit?

Dream two · Post by **Dream two** » Thu Jan 05, 2017 3:07 pm

you're right LM. When I go around the tank with a magnet It's clear that in the areas that would have been filled in there is noticeable less pull on the magnet than the other areas. hope I can salvage the fuel cock. Any tricks to undoing to bottom, pot metal part, without destroying it?

Rudy LI NY

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Jan 05, 2017 3:20 pm

I didn't see a cap but looked at the 12 other parts for that bike he has listed. .....................lm

Dream two wrote:What about the cap. Real weird and says" not vented" Probably a catch all that happened to Fit?

LOUD MOUSE · Post by **LOUD MOUSE** » Thu Jan 05, 2017 3:44 pm

Bout all I can recommend is plenty of release type liquid before you take a wrench to it. .........lm

Dream two wrote:you're right LM. When I go around the tank with a magnet It's clear that in the areas that would have been filled in there is noticeable less pull on the magnet than the other areas. hope I can salvage the fuel cock. Any tricks to undoing to bottom, pot metal part, without destroying it?

Rudy LI NY

Honda305.com Forum