Needed Switch Winker 1959-60 C77-72 Dream

up100 · Post by **up100** » Sat Nov 07, 2015 3:48 pm

Dear Friends

I am looking for Switch Winker 1959-60 C77-72 Dream Right Hand ,,

press steel bar model.

Please anyone has it for trade can you let me know ,, Really need it for my C77 Dream..

Thank you
Aup

DianneB · Post by **DianneB** » Sun Nov 08, 2015 5:26 am

I am not familiar with the "pressed steel bar" type but I will have some parts available for the 7/8" tubular bars in a few months if that helps.

G-Man · Post by **G-Man** » Sun Nov 08, 2015 5:51 am

The style is different but a later switch could be made to work.

The switch for the pressed-bar model is square in profile to match the handlebar.

G

DianneB wrote:I am not familiar with the "pressed steel bar" type but I will have some parts available for the 7/8" tubular bars in a few months if that helps.

up100 · Post by **up100** » Sun Nov 08, 2015 4:24 pm

Dear friend

My Honda very similar to Mr G

Still searching .....

LOUD MOUSE · Post by **LOUD MOUSE** » Sun Nov 08, 2015 6:28 pm

Anything over there that doesn't rust/corrode?. ..............lm

G-Man wrote:The style is different but a later switch could be made to work.

The switch for the pressed-bar model is square in profile to match the handlebar.

G

DianneB wrote:I am not familiar with the "pressed steel bar" type but I will have some parts available for the 7/8" tubular bars in a few months if that helps.

G-Man · Post by **G-Man** » Mon Nov 09, 2015 1:55 am

LM

Well yes, most metals have a hard time here. Interestingly though, rubber and plastic parts last really well and don't crack and crumble like they do in hotter parts of the US.

That Dream had been in a damp shed for 40-50 years. The origial owner fell off in the '60s and lost interest. I think it's probably done less than 5000 miles.

G

LOUD MOUSE wrote:Anything over there that doesn't rust/corrode?. ..............lm

G-Man wrote:The style is different but a later switch could be made to work.

The switch for the pressed-bar model is square in profile to match the handlebar.

G

DianneB wrote:I am not familiar with the "pressed steel bar" type but I will have some parts available for the 7/8" tubular bars in a few months if that helps.

LOUD MOUSE · Post by **LOUD MOUSE** » Mon Nov 09, 2015 3:42 am

Not a lot of those around today. ..................lm

G-Man wrote:LM

Well yes, most metals have a hard time here. Interestingly though, rubber and plastic parts last really well and don't crack and crumble like they do in hotter parts of the US.

That Dream had been in a damp shed for 40-50 years. The origial owner fell off in the '60s and lost interest. I think it's probably done less than 5000 miles.

G

LOUD MOUSE wrote:Anything over there that doesn't rust/corrode?. ..............lm

G-Man wrote:The style is different but a later switch could be made to work.

The switch for the pressed-bar model is square in profile to match the handlebar.

G

DianneB wrote:I am not familiar with the "pressed steel bar" type but I will have some parts available for the 7/8" tubular bars in a few months if that helps.