cb77 clutch cable "joint"

klp · Post by **klp** » Tue Jan 13, 2015 5:42 pm

That's what the fiche calls it - the junction where the cable threads into the right side case.

Has anyone got one?

OldScrambler · Post by **OldScrambler** » Sun Feb 08, 2015 4:48 pm

Early models are at a 90-degree angle to the case..............later models are at about 75 or 80-degrees to the case. Which do you need..........then I will look in my parts stash..........likely have one or more of each.

ahenthus · Post by **ahenthus** » Sun Feb 08, 2015 9:08 pm

OldScrambler wrote:Early models are at a 90-degree angle to the case..............later models are at about 75 or 80-degrees to the case. Which do you need..........then I will look in my parts stash..........likely have one or more of each.

OldScrambler, Welcome to the forum. I need a 66 scrambler clutch joint too. Mine is slightly less than 90 deg, looks close to 86-88 deg. i.e. the clutch cable enters the case almost perpendicularly. Please advise.
CLaude

OldScrambler · Post by **OldScrambler** » Mon Feb 09, 2015 10:21 am

I'll start digging................

OldScrambler · Post by **OldScrambler** » Tue Feb 24, 2015 2:01 pm

OK............I work REAL slow when its REAL cold............so when it warmed into the 20s today I dug up a few clutch cables with the 'joint' attached. Only one unit (far right) was found that is nearly 90-degrees and it has a partially broken 'wing' that slips beneath the case. It will work as-is (but not recommended for extended use) or could be repaired........The other units have the somewhat sloped angle and are thought to provide less stress to operate. If you or anyone else is interested in any of the 'joints' $20 shipped to the lower 48 from Wisconsin.

ahenthus · Post by **ahenthus** » Tue Feb 24, 2015 11:46 pm

Man, when you say you'll be digging you really do dig. That's quite an impressive tangle of clutch joints & cables. PM sent.

ahenthus · Post by **ahenthus** » Sat Feb 28, 2015 12:04 am

Hello, anybody home? OldScrambler, I pm'd you and also left the post before this. Please check your messages.
Thanks,
Claude