Adjusting Valves

sibes67 · Post by **sibes67** » Thu Dec 27, 2012 10:26 pm

Been trying, in vain, to find some type of tutorial for valve clearance adjustment. Where to look for this? Thanks,
Ron

LOUD MOUSE · Post by **LOUD MOUSE** » Fri Dec 28, 2012 8:36 am

Set rotor to "T" and adjust both right side valves to .004.
Set to "LT" and adjust left side.
You will need to lock down the rotor to do this. ...........lm

sibes67 wrote:Been trying, in vain, to find some type of tutorial for valve clearance adjustment. Where to look for this? Thanks,
Ron

sibes67 · Post by **sibes67** » Fri Dec 28, 2012 4:32 pm

LOUD MOUSE wrote:Set rotor to "T" and adjust both right side valves to .004.
Set to "LT" and adjust left side.
You will need to lock down the rotor to do this. ...........lm

sibes67 wrote:Been trying, in vain, to find some type of tutorial for valve clearance adjustment. Where to look for this? Thanks,
Ron

OK sounds good, but to be sure and since I have never done this before, here is a picture of where I think I approach this procedure...does the feeler gage insert under the adjusting screw and on top of the valve stem? The gauge hardly goes in very far right now, and I do have rotor lockied at T for this right side shot (shows intake, but the exhaust was really tight too). Thanks for the direction.

Tappet Adjustment by sibes67, on Flickr

Ford Guy · Post by **Ford Guy** » Fri Dec 28, 2012 7:51 pm

It may be a little difficult with that feeler gauge. The one that came in the original tool kit is much narrower. The wider gauge will hang up on the valve cap making it harder to feel the clearance. What I did was cut my gauge down with a very sharp scissors and made sure there was not a burr on the sides. Other than that you are on the right track

sibes67 · Post by **sibes67** » Sat Dec 29, 2012 3:46 pm

My feeler gauge is 1/2 inch wide, most likely a automotive type gauge and not made for these bikes, and it did not come in the tool kit. My tool kit did not have a gauge in it; I will search for a different one that is easier to use. Thanks.

CliffC · Post by **CliffC** » Sat Dec 29, 2012 7:12 pm

Narrower is what you need and if it has a bend in it, that's even better. I have a set that has about a 65 degree bend about an inch from the end, had them for years but don't remember where I got them. Cliff

brewsky · Post by **brewsky** » Sat Dec 29, 2012 7:48 pm

Make sure the 'T' and 'LT' are when the piston is on compression stroke.

Honda305.com Forum

Adjusting Valves

Adjusting Valves

Re: Adjusting Valves

Re: Adjusting Valves