crankshaft

teekay · Post by **teekay** » Sat Jun 19, 2010 7:23 pm

What is the special tool to remove the rotor on the right side of the crankshaft on a CB77?

teazer · Post by **teazer** » Sun Jun 20, 2010 3:14 am

To remove the alternaotor rotor use the rear axle and to remove the oil slinger nut cut down a suitable socket after knocking back the locking tab.

Mike Mullins · Post by **Mike Mullins** » Sun Jun 20, 2010 7:04 am

I posted this sometime back. I dont think there's a bolt on the bike that will work
Mikeyrx

I posted the same question early November, and then found the answer. ( The post is listed under "rotor removal", and I think the date is Nov 2 or thereabouts. You need a 16mm bolt with a 1.5 mm. thread pitch. Needs to be about 1-1/2 in long ( about 38 mm. more or less. ) I found that this size is not normally stocked anywhere. I got mine at Sanders Indiana Hardware in Valparaiso, IN. They are a fastener wholesaler, and I went to grade school and high school with all the Sanders kids. I could not find ANY other bolt on my CB 77 that would work for pulling the rotor.
Mike Mullins (mikeyrx)

jensen · Post by **jensen** » Sun Jun 20, 2010 11:01 am

Hi,

No, you will find the axle on early dreams,

Jensen

davomoto · Post by **davomoto** » Sun Jun 20, 2010 3:56 pm

Motion Pro sells a puller for around $10. motionpro.com

Scram64 · Post by **Scram64** » Mon Jun 21, 2010 2:20 pm

davomoto wrote:Motion Pro sells a puller for around $10. motionpro.com

Try this site address http://www.motionpro.com/motorcycle/partno/08-0027
Scram64

rustywrench · Post by **rustywrench** » Mon Jun 21, 2010 4:23 pm

I once bought a chain breaker from Harbor Freight and found that the large bolt from that tool worked for removing the rotor. WOW!!!!!! Two tools for the price of one. RW

Honda305.com Forum

crankshaft

crankshaft

rotor removal

crankshaft

rotor remover