Oil filter o-rings

lhz55 · Post by **lhz55** » Tue Jul 29, 2008 7:39 am

Is the dash number available. It would help my search.
Thanks, Lee

~Aron~ · Post by **~Aron~** » Tue Jul 29, 2008 7:58 am

SKU: 91303-PH8-010
O-RING (79.4X3.1) (Honda Code 1994359) Outer

SKU: 91309-700-010
O-RING (74.5X3) (Honda Code 0002725) Inner

lhz55 · Post by **lhz55** » Tue Jul 29, 2008 8:21 am

Thank You,
Lee

lhz55 · Post by **lhz55** » Tue Jul 29, 2008 8:43 am

Thank You very much. My basket case restore only had the inner gasket on it. I did not realize their was an inner and outer until your reply.
Once again thank You.
Lee

56_oval · Post by **56_oval** » Wed Mar 30, 2011 3:49 pm

I know this is an old post, but where do the o-rings go? Is there a lip for the inner and outer? I'm asking cause my gasket set didn't come with any and my engine leaks oil from the oil filter cover.

davomoto · Post by **davomoto** » Wed Mar 30, 2011 4:46 pm

There's a lip for the inner, and tthe outer goes against the cover.

Davo

56_oval · Post by **56_oval** » Thu Mar 31, 2011 4:32 pm

So I found a set of 79 and 75mm orings. They were way too large. Is there a difference in side covers? Early and late? My bike is a '64