Wheel Bearings...

[carlluvscorinne]

Hello all: Just wondering if there is any special trick to removing the front & rear wheel bearings from the hubs? I removed the 3 phillips screws and the stamped steel plate, should they now just fall out or do I have to use some sort of puller? Machine is a "64" CB77.
Thanx, Carl

[wombat200]

They are pressed in (like any other wheel bearing!), so need to be pulled or drifted out...

[DavidK]

I usually find that it helps to heat the hub with a hot air gun first.

[Bob Dale]

What about the rubber seals that are pressed into the inside of both sides and to the outer edge of the speedometer sending unit housing? Can those be replaced?

[splitpile]

No, they are no longer available.