Honda305.com Forum

Hello, I am putting my clutch side cover on after rebuilding the transmission and top end and there is one bolt that I cannot figure out. It holds a metal plate below the starter chain, but it is also the same hole the clutch cover uses. Did I put the metal piece in the wrong spot? Is there a specia...

I'm installing my cams and I read that the sprocket should have .002"-.004" side play. After I install my side covers for the cylinder head I find there is no side play. What should I do to correct this?

I'm putting the camshaft back into the cylinder head. I wanted to make sure the parts I'm using are okay. One camshaft looks a little discolored/ worn (see photo). I checked the sprocket for any movement due to loose rivets and it is fine. There is less than.1" play in the weights, should I try and ...

Hello all, I've been away from home for the past 3-4 months, now I'm back and ready to get this engine complete. I ran into transmission problems that eventually LoudMouse solved, it was a bad bearing. Now I'm putting the cylinder studs back into the case and wanted to know the following: 1.) what i...

Hi Guys, Thanks for the replies. One thing I should of noted is the kickstart prawl is not in the transmission right now. I did have the kickstart prawl in the transmission, but when this issue came up I have been taking it apart and reassembling it to try and figure out why it is not turning smooth...

I changed the location of the two gears that do not have the C clips with the wire ring and it made the transmission worse, you could not even get the kickstart spindle shaft to seat in its place. I went over the gears again, counted the teeth, everything is in the right place. I don't know what's w...

would you try just replacing that bearing?

Thanks for the reply.