Honda305.com Forum

The most difficult part was putting on the spring. Pennies help a great deal. Bend the spring andinsert pennies between each coil on both sides. This helps stretch the spring.

For the mobile users like myself it would be nice if the forum was enabled for Tapatalk a popular app for mobile devices. What is Tapatalk? Tapatalk is a mobile app built specifically for forum access. Tapatalk allows user to have a unified interface to access multiple forums at the same time. Many ...

From the Clymers manual the float height should be set to 19.5 mm or .77 inches. I also have the service manual and measurements in there are the same. Be happy to scan manual pages and send to you.

This was a great help on my CB160. At first the light was coming when I passed the F mark the I readjusted the points and the light came on when I reached F mark. It fired up and ran great. So many thanks

I recently purchase a 65 CB160. The CB160 center stand was removed and replaced with a custom side stand. I am trying to re-install a center stand because I am afraid the bike might tip over with the stand. I have been unable to find any good parts diagrams that show how or where the stand should bo...

I wanted to post this so everyone could benefit from this knowledge. [quote="hishairisred"]Hey CSW, Its pretty simple, you need to run a two wire cable from the switch, through the bars, down the headstock and under the tank along the frame to the fuse behind the battery. cut the wires on the end of...

Thanks for the tips so far. I am definitely going to get my switch from DCC and also the blinkers. I noticed there is a possibility for a kill switch on the control. Is this something you did on your controls? Any pictures you can post on wiring would be a great help. Flasher Relay: http://www.dimec...